The kdFi V1.4 is installed in a Motronic compatible housing and loaded with an initial setup for M40 engines. (not for the E36 with 88-pin control unit) The control unit can be used on the following Bosch Motronics: 0 261 200 157 0 261 200 174 0 261 200 387 0 261 200 989 If your number is not listed, please contact us, using the contact form
Customer to do: - Replace Throttle Position Switch with Throttle Position Sensor e.g. from M50 engine (not included in delivery) - Change Engine Management - START ENGINE !
This product is only street legal with special permission in most countries. Please check local laws before using on official streets. Automatic transmissions are currently not supported.
Features: - MAP sensor based setup (can be changed to alpha-N via software) - also suitable for turbo and compressor conversions - full compatible to MSextra Software - build your own setup - MS2 onboard / Firmware MS2extra - Fuel Table 16x16 - Ignition Table 12x12 - USB Connector - Widebandlambdacontroller (www.breitband-lambda.de) - prepared for single coils (seperate wires needs to be connected) - supports stock idle valves - user programmable relay output - electronical boost control - supports CAN Bus - compatible with the Lambda Sensor LSU 4.2
Scope of delivery: - kdFi V1.4 Plug and Play ECU - USB Cable - kdFi Manual - from 01.05.24 no CD included, download software CD under available downloads
