Accessories

Compatible accessories and supplements for our Engine Control Units.

The Lambda Sensor LSU 4.2 and the Lambdasensor Connector are particularly recommended.
Both components are connected to each other, can be plugged directly into the ECU and are already preset on the ECU.

Compatible accessories and supplements for our Engine Control Units. The  Lambda Sensor LSU 4.2  and the Lambdasensor Connector  are particularly recommended. Both components are... read more »
Close window
Accessories

Compatible accessories and supplements for our Engine Control Units.

The Lambda Sensor LSU 4.2 and the Lambdasensor Connector are particularly recommended.
Both components are connected to each other, can be plugged directly into the ECU and are already preset on the ECU.

Filter
Close filters
 
  •  
from to
No results were found for the filter!
NoKnock PNP NoKnock PNP
Adaptiv module for knock detection with standard knocksensors - direct plug in on all kdFi V1.4 PNP with 4 pin external connector - Signal usable in Tunerstudio at input AD7 / JS4 - additional open collector output e.g. for signal light...
€159.00 *
Bluetooth Module Bluetooth Module
This Bluetooth Modul works with all kdFi V1.4. Just plug it between kdFi V1.4 Modul and the lower PCB. It is preconfigured for 115200 Baud. Easy installation without soldering. Please notify there are housing modifications needed for...
€59.00 *
Boost sensor 3 bar Boost sensor 3 bar
Absolute Pressure Sensor up to 3 bar boost (4 bar absolute) can be used as alternative for high boost engines
€25.00 *
Barometric Sensor Barometric Sensor
Barometric sensor for permanent altitude correction
€25.00 *
Lambda Sensor LSU 4.2 Lambda Sensor LSU 4.2
Wideband Lambda Sensor LSU 4.2 - used with integrated kdFi V1.4 Lambdacontroller - spare part for LC-1
€84.95 *
Lambdasensor Connector Lambdasensor Connector
Prepared connection cable for the Lambdasonde LSU 4.2, ready to plug in for the PNP Engine Control Units
€24.90 *
kdFi V1.4 plug set Cinch kdFi V1.4 plug set Cinch
Plug Set for kdFi V1.4 with housing
€24.90 *
kdFi V1.4 plug set PNP kdFi V1.4 plug set PNP
Plug set for kdFi V1.4 PNP engine control units
€9.00 *
MPX4250 MPX4250
Absolute Pressure Sensor up to 3 bar boost (4 bar absolute) can be used as alternative for high boost engines
€17.00 *
kdFi Repair kdFi Repair
Order only after consultation!
€15.00 *
Replacement board kdFi V1.4 PNP BMW M52TU Replacement board kdFi V1.4 PNP BMW M52TU
Order only after consultation!
€250.00 *
Viewed

This website uses cookies to provide you with the best possible functionality. If you do not agree, the following functions are not available to you:

Accept Close